docu2
This commit is contained in:
1 parent
f67eb452e3
commit
243f1a0861
1 file changed
+10
-5
@@ -101,10 +101,16 @@ hf 14a read --drop
|
||||
```
|
||||
|
||||
## I Have A BWM, Now What?
|
||||
|
||||
### Install
|
||||
* You acknowledge that the BWM is not yet fully supported, it's better not to plug it for now. (If you insist... continue.)
|
||||
* [Physically install the BWM and (if applicable) Battery](https://github.com/RfidResearchGroup/Proxmark5_BWM_esp32/blob/master/INSTALL.md)
|
||||
|
||||
### Operation
|
||||
* Power on: Briefly pressing the button will wake the device. The RGB will turn green
|
||||
** The RGB will turn green.
|
||||
* When the device is powered on, pressing and holding the button for a few seconds will start displaying a running light, and then releasing the button will power off the device
|
||||
|
||||
|
||||
|
||||
## DFU Install
|
||||
@@ -115,9 +121,6 @@ hf 14a read --drop
|
||||
|
||||
|
||||
|
||||
## Standalone Modes
|
||||
|
||||
Standalone modes are disabled for now, to ease debugging.
|
||||
|
||||
## BWM aka Battery Wireless Module
|
||||
|
||||
@@ -125,8 +128,6 @@ Standalone modes are disabled for now, to ease debugging.
|
||||
|
||||
* [Installation instructions](https://github.com/RfidResearchGroup/Proxmark5_BWM_esp32/blob/master/INSTALL.md)
|
||||
* The very first time, run ` hw bwmsetcap --cap 500` and do a full charge/discharge cycle for it to learn the real capacity
|
||||
* Pressing briefly the button will wake the device. The RGB will turn green
|
||||
* When the device is powered on, pressing and holding the button for a few seconds will start displaying a running light, and then releasing the button will power off the device
|
||||
|
||||
## Recovery flashing via DFU
|
||||
|
||||
@@ -202,3 +203,7 @@ Do not use them unless you fully understand what you're doing.
|
||||
* `hw qc_pm5`: factory quality check command, will activate the RBG, the buzzer and the antenna LEDs. Press the button to report success. Use `-t/--timeout <s>` to change how long the test sequence runs before it fails (default 20 seconds).
|
||||
* `hw factorydata`: read/write the factory data (originality signature etc)
|
||||
|
||||
|
||||
## Standalone Modes
|
||||
|
||||
Standalone modes are disabled for now, to ease debugging.
|
||||
Reference in new issue
Block a user