diff --git a/doc/md/PM5_Start_Here/Getting_Started_With_PM5.md b/doc/md/PM5_Start_Here/Getting_Started_With_PM5.md index dcb2fc0cb..b5b3a4208 100644 --- a/doc/md/PM5_Start_Here/Getting_Started_With_PM5.md +++ b/doc/md/PM5_Start_Here/Getting_Started_With_PM5.md @@ -101,10 +101,16 @@ hf 14a read --drop ``` ## I Have A BWM, Now What? + ### Install * You acknowledge that the BWM is not yet fully supported, it's better not to plug it for now. (If you insist... continue.) * [Physically install the BWM and (if applicable) Battery](https://github.com/RfidResearchGroup/Proxmark5_BWM_esp32/blob/master/INSTALL.md) +### Operation +* Power on: Briefly pressing the button will wake the device. The RGB will turn green +** The RGB will turn green. +* When the device is powered on, pressing and holding the button for a few seconds will start displaying a running light, and then releasing the button will power off the device + ## DFU Install @@ -115,9 +121,6 @@ hf 14a read --drop -## Standalone Modes - -Standalone modes are disabled for now, to ease debugging. ## BWM aka Battery Wireless Module @@ -125,8 +128,6 @@ Standalone modes are disabled for now, to ease debugging. * [Installation instructions](https://github.com/RfidResearchGroup/Proxmark5_BWM_esp32/blob/master/INSTALL.md) * The very first time, run ` hw bwmsetcap --cap 500` and do a full charge/discharge cycle for it to learn the real capacity -* Pressing briefly the button will wake the device. The RGB will turn green -* When the device is powered on, pressing and holding the button for a few seconds will start displaying a running light, and then releasing the button will power off the device ## Recovery flashing via DFU @@ -202,3 +203,7 @@ Do not use them unless you fully understand what you're doing. * `hw qc_pm5`: factory quality check command, will activate the RBG, the buzzer and the antenna LEDs. Press the button to report success. Use `-t/--timeout ` to change how long the test sequence runs before it fails (default 20 seconds). * `hw factorydata`: read/write the factory data (originality signature etc) + +## Standalone Modes + +Standalone modes are disabled for now, to ease debugging.