added section what to do if the decoder does not work
1 parent
3cd3df6faf
commit
9f33028ddd
1 file changed
+6
-1
+6
-1
@@ -49,4 +49,9 @@ Please refer to [Getting started - Pico](https://datasheets.raspberrypi.com/pico
|
||||
The illustration above shows an example wiring configuration, you can connect up to 4 outputs(up to 400mA) and 6 GPIOs for lighter loads or custom applications. A Free-wheeling diode should be used when switching inductive loads!
|
||||
|
||||
Another important note is that when the decoder is put into operation for the first time, it automatically performs a motor calibration, which is required for feedforward control. The calibration takes about one to two minutes.
|
||||
|
||||
|
||||
## 5. If it's not working as expected
|
||||
|
||||
- check the power supply of the decoder (from rails and the +3.3V)
|
||||
- if the motor acts strange desolder the wires to the motor and try the motor with a analog power supply 0..+-16V to check if the motor is working or not (desolder the wires because the decoder doesn't like electricity on these pins!)
|
||||
- try to reset the decoder by writing 8 to CV8 (beware, this will reset the complete CV memory!)
|
||||
Reference in new issue
Block a user