diff --git a/Getting-started.md b/Getting-started.md index 7d1ab58..165ec74 100644 --- a/Getting-started.md +++ b/Getting-started.md @@ -49,4 +49,9 @@ Please refer to [Getting started - Pico](https://datasheets.raspberrypi.com/pico The illustration above shows an example wiring configuration, you can connect up to 4 outputs(up to 400mA) and 6 GPIOs for lighter loads or custom applications. A Free-wheeling diode should be used when switching inductive loads! Another important note is that when the decoder is put into operation for the first time, it automatically performs a motor calibration, which is required for feedforward control. The calibration takes about one to two minutes. - \ No newline at end of file + +## 5. If it's not working as expected + +- check the power supply of the decoder (from rails and the +3.3V) +- if the motor acts strange desolder the wires to the motor and try the motor with a analog power supply 0..+-16V to check if the motor is working or not (desolder the wires because the decoder doesn't like electricity on these pins!) +- try to reset the decoder by writing 8 to CV8 (beware, this will reset the complete CV memory!)