Refine OTA command and timeout configurations
Updated OTA command definitions and timeout settings. Signed-off-by: Niel Nielsen <nieldk@gmail.com>
This commit is contained in:
1 parent
423ede5d29
commit
e2cefcff3a
1 file changed
+9
-9
+9
-9
@@ -70,22 +70,22 @@ int bwm_wifi_forward_status(uint8_t *state, uint32_t *ip_out);
|
||||
// ESP OTA over the BWM UART link (no header/soldering): drives the ESP's own
|
||||
// OTA commands to reflash a *working* BWM to a new ESP image.
|
||||
#define BWM_CMD_OTA_BEGIN 1800 // req: u32 total size
|
||||
#define BWM_CMD_OTA_WRITE 1801 // req: [offset:u32 LE][firmware chunk] (idempotent by offset)
|
||||
#define BWM_CMD_OTA_WRITE 1801 // req: firmware chunk
|
||||
#define BWM_CMD_OTA_END 1802 // no payload: finalize + set boot partition
|
||||
// After a working OTA_END, the ESP has marked the new partition bootable but
|
||||
// does not reboot on its own - REBOOT must be sent explicitly (DEV.md 12.8).
|
||||
#define BWM_CMD_REBOOT 1803
|
||||
// Run the OTA at a slow, reliable baud (restored to the fast rate at end/abort).
|
||||
#ifndef BWM_OTA_WRITE_RETRIES
|
||||
#define BWM_OTA_WRITE_RETRIES 4 // per-chunk retries (ESP is idempotent on offset)
|
||||
// BEGIN erases (or finishes aborting) an OTA slot. A 1.8 MB erase on ESP32-C2
|
||||
// commonly takes 20-40 s, so this must be well above the old 15 s race.
|
||||
#ifndef BWM_OTA_BEGIN_TIMEOUT_MS
|
||||
#define BWM_OTA_BEGIN_TIMEOUT_MS 60000
|
||||
#endif
|
||||
#ifndef BWM_OTA_WRITE_TO
|
||||
#define BWM_OTA_WRITE_TO 3000 // per-try ack wait (ms); 4x stays under client 15s
|
||||
#endif
|
||||
#ifndef BWM_OTA_BAUD
|
||||
#define BWM_OTA_BAUD 460800
|
||||
#ifndef BWM_OTA_WRITE_TIMEOUT_MS
|
||||
#define BWM_OTA_WRITE_TIMEOUT_MS 20000
|
||||
#endif
|
||||
#define BWM_CMD_GET_VERSION_INFO 1000 // resp: running firmware version string
|
||||
#define BWM_CMD_STOP_BLE_SPP 4022 // no payload: stop BLE during OTA (flash contention)
|
||||
#define BWM_CMD_START_BLE_SPP 4021 // no payload: restore BLE after OTA
|
||||
#define BWM_CMD_SET_BLE_DEVICE_NAME 4002 // req: name bytes
|
||||
#define BWM_CMD_GET_BLE_DEVICE_NAME 4003 // resp: current BLE device name string
|
||||
int bwm_esp_get_version(uint8_t *buf, uint16_t *buflen);
|
||||
|
||||
Reference in new issue
Block a user