FPGA: lo_read.v merged.
This commit is contained in:
1 parent
42bf0d4926
commit
36bfb81538
1 file changed
+31
-3
+31
-3
@@ -29,7 +29,7 @@ module lo_read(
|
||||
input lf_field,
|
||||
|
||||
output ssp_din,
|
||||
output ssp_frame,
|
||||
output reg ssp_frame,
|
||||
output ssp_clk,
|
||||
output adc_clk,
|
||||
output pwr_lo,
|
||||
@@ -74,8 +74,27 @@ end
|
||||
assign ssp_din = to_arm_shiftreg[7] && !pck_divclk;
|
||||
// SSP clock always runs at 24MHz
|
||||
assign ssp_clk = pck0;
|
||||
// SSP frame is gated by pck_divclk and goes high when pck_cnt=8..15
|
||||
assign ssp_frame = (pck_cnt[7:3] == 5'd1) && !pck_divclk;
|
||||
|
||||
// ssp_frame window: TI = 1-cycle pulse (at counter 7), SSP = spans the entire data window (counts 8-15).
|
||||
// Note: The 'always' block below reads the value of pck_cnt *before* it toggles for the current cycle,
|
||||
// so SET is triggered at the window start minus 1, and CLR is triggered at the window end.
|
||||
`ifdef WITH_TIMODE
|
||||
`define LO_READ_FRAME_SET 8'd6
|
||||
`define LO_READ_FRAME_CLR 8'd7
|
||||
`else
|
||||
`define LO_READ_FRAME_SET 8'd7
|
||||
`define LO_READ_FRAME_CLR 8'd15
|
||||
`endif
|
||||
|
||||
// Frame signal generation.
|
||||
always @(posedge pck0)
|
||||
begin
|
||||
if ((pck_cnt == `LO_READ_FRAME_SET) && !pck_divclk)
|
||||
ssp_frame <= 1'b1;
|
||||
if ((pck_cnt == `LO_READ_FRAME_CLR) && !pck_divclk)
|
||||
ssp_frame <= 1'b0;
|
||||
end
|
||||
|
||||
// unused signals tied low
|
||||
assign pwr_hi = 1'b0;
|
||||
// always on outputs, unused
|
||||
@@ -85,8 +104,17 @@ assign pwr_oe3 = 1'b0;
|
||||
assign pwr_oe4 = 1'b0;
|
||||
// this is the antenna driver signal
|
||||
assign pwr_lo = lf_field & pck_divclk;
|
||||
|
||||
// ADC clock out of phase with antenna driver
|
||||
`ifdef PM5
|
||||
// Since the PM5's ADC sampling occurs on the rising edge,
|
||||
// whereas the falling edge of the field signal causes a rapid voltage rise, making it unsuitable for sampling,
|
||||
// the phase was adjusted to align them.
|
||||
assign adc_clk = pck_divclk;
|
||||
`else
|
||||
assign adc_clk = ~pck_divclk;
|
||||
`endif
|
||||
|
||||
// ADC clock also routed to debug pin
|
||||
assign debug = adc_clk;
|
||||
endmodule
|
||||
Reference in new issue
Block a user