Destroyed Quick start guide (Windows) (markdown)
1 parent
80c2bba033
commit
b2f0cc4536
1 file changed
-18
@@ -1,18 +0,0 @@
|
|||||||
1. Download and install [Pico setup for Windows from ndabas](https://github.com/ndabas/pico-setup-windows) and make sure to check the box for also installing Zadig.
|
|
||||||
2. Clone and build Pico repos either by checking the box at the end of the setup.
|
|
||||||
3. Connect Raspberry Pi Pico via USB while holding the reset button. Your Pi Pico should now be visible in Windows explorer as a mass storage device.
|
|
||||||
4. Navigate to the picoprobe/build subfolder in your installation folder and copy picoprobe.uf2 to your Pi Pico. Alternatively, download the picoprobe.uf2 file from [here](https://www.raspberrypi.com/documentation/microcontrollers/raspberry-pi-pico.html#debugging-using-another-raspberry-pi-pico).The Pi Pico onboard LED should now be on.
|
|
||||||
5. Navigate to the tools subfolder in your installation folder and open zadig.exe
|
|
||||||
6. Install the picoprobe driver using zadig.exe as shown in [Getting started with Raspberry Pi Pico - Appendix A - Page 62](https://datasheets.raspberrypi.com/pico/getting-started-with-pico.pdf#%5B%7B%22num%22%3A65%2C%22gen%22%3A0%7D%2C%7B%22name%22%3A%22XYZ%22%7D%2C115%2C692.106%2Cnull%5D)
|
|
||||||
7. Connect GND to GND, VBUS to +V, GPIO2 to SWCLK, GPIO3 to SWDIO as shown in the picture below.
|
|
||||||
|
|
||||||
<img src="https://github.com/gab-k/RP2040-Decoder/blob/main/docs/svg/Debug_Connections.svg" width="700"/>
|
|
||||||
|
|
||||||
8. To finally build and flash, open the Developer Command Prompt for Pico and type the following commands:
|
|
||||||
* git clone https://github.com/gab-k/RP2040-Decoder.git
|
|
||||||
* cd RP2040-Decoder
|
|
||||||
* mkdir build
|
|
||||||
* cd build
|
|
||||||
* cmake -G "NMake Makefiles" ..
|
|
||||||
* nmake
|
|
||||||
* openocd -f interface/picoprobe.cfg -f target/rp2040.cfg -c "program RP2040-decoder.elf verify reset exit"
|
|
||||||
Reference in new issue
Block a user