From b2f0cc4536813132273926332cd70cd10446f4e8 Mon Sep 17 00:00:00 2001 From: Gabriel Koppenstein <82903393+gab-k@users.noreply.github.com> Date: Sat, 6 Aug 2022 14:11:24 +0200 Subject: [PATCH] Destroyed Quick start guide (Windows) (markdown) --- Quick-start-guide-(Windows).md | 18 ------------------ 1 file changed, 18 deletions(-) delete mode 100644 Quick-start-guide-(Windows).md diff --git a/Quick-start-guide-(Windows).md b/Quick-start-guide-(Windows).md deleted file mode 100644 index 6808446..0000000 --- a/Quick-start-guide-(Windows).md +++ /dev/null @@ -1,18 +0,0 @@ -1. Download and install [Pico setup for Windows from ndabas](https://github.com/ndabas/pico-setup-windows) and make sure to check the box for also installing Zadig. -2. Clone and build Pico repos either by checking the box at the end of the setup. -3. Connect Raspberry Pi Pico via USB while holding the reset button. Your Pi Pico should now be visible in Windows explorer as a mass storage device. -4. Navigate to the picoprobe/build subfolder in your installation folder and copy picoprobe.uf2 to your Pi Pico. Alternatively, download the picoprobe.uf2 file from [here](https://www.raspberrypi.com/documentation/microcontrollers/raspberry-pi-pico.html#debugging-using-another-raspberry-pi-pico).The Pi Pico onboard LED should now be on. -5. Navigate to the tools subfolder in your installation folder and open zadig.exe -6. Install the picoprobe driver using zadig.exe as shown in [Getting started with Raspberry Pi Pico - Appendix A - Page 62](https://datasheets.raspberrypi.com/pico/getting-started-with-pico.pdf#%5B%7B%22num%22%3A65%2C%22gen%22%3A0%7D%2C%7B%22name%22%3A%22XYZ%22%7D%2C115%2C692.106%2Cnull%5D) -7. Connect GND to GND, VBUS to +V, GPIO2 to SWCLK, GPIO3 to SWDIO as shown in the picture below. - - - -8. To finally build and flash, open the Developer Command Prompt for Pico and type the following commands: -* git clone https://github.com/gab-k/RP2040-Decoder.git -* cd RP2040-Decoder -* mkdir build -* cd build -* cmake -G "NMake Makefiles" .. -* nmake -* openocd -f interface/picoprobe.cfg -f target/rp2040.cfg -c "program RP2040-decoder.elf verify reset exit"