Updated Quick start guide (Windows) (markdown)
1 parent
57f749aa6a
commit
8634e9bfd0
1 file changed
+19
-1
@@ -1 +1,19 @@
|
|||||||
1.
|
1. Connect Raspberry Pi Pico via USB while holding the reset button. Your Pi Pico should now be visible in Windows explorer as a mass storage device.
|
||||||
|
2. Download the picoprobe.uf2 file from [here](https://www.raspberrypi.com/documentation/microcontrollers/raspberry-pi-pico.html#debugging-using-another-raspberry-pi-pico)
|
||||||
|
3. Copy picoprobe.uf2 to your Pi Pico using Windows explorer. The Pi Pico onboard LED should now be on.
|
||||||
|
4. Download [Pico setup for Windows from ndabas](https://github.com/ndabas/pico-setup-windows) and make sure to check the box for Zadig while installing.
|
||||||
|
5. Check the box for Clone and build Pico repos.
|
||||||
|
6. Navigate to the tools subfolder in your installation folder and open zadig.exe
|
||||||
|
7. Install the picoprobe driver using zadig.exe as shown in [Getting started with Raspberry Pi Pico - Appendix A - Page 62](https://datasheets.raspberrypi.com/pico/getting-started-with-pico.pdf#%5B%7B%22num%22%3A65%2C%22gen%22%3A0%7D%2C%7B%22name%22%3A%22XYZ%22%7D%2C115%2C692.106%2Cnull%5D)
|
||||||
|
8. Connect GND to GND, VSYS to 3V3, GPIO2 to SWCLK, GPIO3 to SWDIO (picture below)
|
||||||
|
|
||||||
|

|
||||||
|
|
||||||
|
9. Open the Developer Command Prompt for Pico and type the following commands:
|
||||||
|
* git clone github.com/gab-k/RP2040-Decoder
|
||||||
|
* cd RP2040-Decoder
|
||||||
|
* mkdir build
|
||||||
|
* cd build
|
||||||
|
* cmake -G "NMake Makefiles"
|
||||||
|
* nmake
|
||||||
|
* openocd -f interface/picoprobe.cfg -f target/rp2040.cfg -c "program RP2040-decoder.elf verify reset exit"
|
||||||
Reference in new issue
Block a user