diff --git a/Quick-start-guide-(Windows).md b/Quick-start-guide-(Windows).md index 1f2b81d..aecfaaf 100644 --- a/Quick-start-guide-(Windows).md +++ b/Quick-start-guide-(Windows).md @@ -1 +1,19 @@ -1. \ No newline at end of file +1. Connect Raspberry Pi Pico via USB while holding the reset button. Your Pi Pico should now be visible in Windows explorer as a mass storage device. +2. Download the picoprobe.uf2 file from [here](https://www.raspberrypi.com/documentation/microcontrollers/raspberry-pi-pico.html#debugging-using-another-raspberry-pi-pico) +3. Copy picoprobe.uf2 to your Pi Pico using Windows explorer. The Pi Pico onboard LED should now be on. +4. Download [Pico setup for Windows from ndabas](https://github.com/ndabas/pico-setup-windows) and make sure to check the box for Zadig while installing. +5. Check the box for Clone and build Pico repos. +6. Navigate to the tools subfolder in your installation folder and open zadig.exe +7. Install the picoprobe driver using zadig.exe as shown in [Getting started with Raspberry Pi Pico - Appendix A - Page 62](https://datasheets.raspberrypi.com/pico/getting-started-with-pico.pdf#%5B%7B%22num%22%3A65%2C%22gen%22%3A0%7D%2C%7B%22name%22%3A%22XYZ%22%7D%2C115%2C692.106%2Cnull%5D) +8. Connect GND to GND, VSYS to 3V3, GPIO2 to SWCLK, GPIO3 to SWDIO (picture below) + +![Placeholder](Placeholder.com) + +9. Open the Developer Command Prompt for Pico and type the following commands: +* git clone github.com/gab-k/RP2040-Decoder +* cd RP2040-Decoder +* mkdir build +* cd build +* cmake -G "NMake Makefiles" +* nmake +* openocd -f interface/picoprobe.cfg -f target/rp2040.cfg -c "program RP2040-decoder.elf verify reset exit"