Add PWM/NoDAC filter and amp examples (#775)

Fixes #562
Fixes #732
This commit is contained in:
Earle F. Philhower, III authored and GitHub committed 2025-10-08 17:30:13 -07:00
1 parent 81ebc8a11a
commit c5613c5a4b
3 files changed
+7

No files matched your search

+7
View File
@@ -240,6 +240,13 @@ If you've built the amp but are not getting any sound, @msmcmickey wrote up a ve
2. If connected properly, do you have ~5 volts between the collector and emitter?
3. Was the transistor possibly damaged/overheated during soldering, or by connecting it improperly? Out-of-circuit diode check voltage drop test using a multimeter from base->emitter and base->collector should be between .5 and .7 volts. If it's shorted or open or conducting in both directions, then replace it and make sure it's connected properly.
### User-Submitted Improvements for 1-Bit Output Modes (Sigma-Delta I2S, PDM)
To improve the quality of the output, a 20kHZ low pass filter (LPF) was suggested by @kimstik
![LPF Schematic](images/lpf.png)
@MarianoSys provided a small amplification circuit that minimizes power draw when idle and provides some visual feedback, described in his [PDF](images/PWM%20audio%20amplifier%20with%20only%201%20transistor,%20power=0%20when%20RX%20signal%20is%20idle%20(high).pdf)
## SPDIF optical output
The proper way would be using optical TOSLINK transmitter (i.e. TOTXxxx). For testing, you can try with ~660nm red LED and resistor. Same as your basic Blink project with external LED, just that the LED will blink a bit faster.
```
BIN
View File
Binary file not shown.

After

Width:  |  Height:  |  Size: 7.2 KiB