# LF_ICEHID — Multi-Format LF Credential Collector > **Author:** Iceman > **Frequency:** LF (125 kHz) > **Hardware:** RDV4 (requires flash memory and battery) [Back to Standalone Modes Index](../../armsrc/Standalone/readme.md#individual-mode-documentation) | [Source Code](../../armsrc/Standalone/lf_icehid.c) | [Development Guide](../../armsrc/Standalone/readme.md#developing-standalone-modes) --- ## What A passive LF credential collector that continuously listens for **HID, IOprox, AWID, and EM4100** cards and logs all captured credentials to flash memory. Runs unattended — just power on and leave it. ## Why This is the ultimate "drop and collect" standalone mode. Place a powered Proxmark3 RDV4 (with battery) near a high-traffic area (like a card reader or badge check-in point) and it silently captures every LF credential that comes into range. Unlike single-protocol modes, IceHID tries all four common LF formats on every signal, catching whatever cards employees are carrying. Use cases: - **Passive badge collection**: Covert long-duration credential harvesting - **Multi-format sites**: Sites using a mix of HID, AWID, IOprox, and EM4100 - **Physical penetration testing**: Leave device near a turnstile, collect badges over hours ## How 1. The Proxmark3 continuously samples the LF antenna 2. On each sample, it attempts demodulation in four formats: HID → AWID → IOprox → EM4100 3. If any format decodes successfully, the credential is logged to `lf_hidcollect.log` on flash 4. The cycle repeats indefinitely until the button is held or USB data is received The multi-format approach uses `ASKDemod()` and protocol-specific decoders in sequence. ## LED Indicators | LED | Meaning | |-----|---------| | **A** (solid) | Reading / recording LF signal | | **B** (solid) | Writing captured data to flash | | **C** (solid) | Unmounting / syncing flash filesystem | ## Button Controls | Action | Effect | |--------|--------| | **Hold 280ms** | Exit standalone mode | | **USB command** | Exit standalone mode | ## State Machine ```mermaid stateDiagram-v2 [*] --> Sample : Startup Sample --> DemodHID : LF signal detected DemodHID --> LogFlash : HID decoded DemodHID --> DemodAWID : HID failed DemodAWID --> LogFlash : AWID decoded DemodAWID --> DemodIO : AWID failed DemodIO --> LogFlash : IOprox decoded DemodIO --> DemodEM : IOprox failed DemodEM --> LogFlash : EM4100 decoded DemodEM --> Sample : All decoders failed LogFlash --> Sample : Logged, continue Sample --> [*] : Button hold / USB data note right of Sample Continuous loop Tries 4 demod formats per signal capture end note ``` ## Flash Storage - **Log file**: `lf_hidcollect.log` on SPI flash - Each entry contains the decoded credential data and format type - Retrieve with client: `mem spiffs dump -s lf_hidcollect.log -d lf_hidcollect.log` ## Compilation ``` make clean make STANDALONE=LF_ICEHID -j ./pm3-flash-fullimage ``` ## Related - [NexID Collector](lf_nexid.md) — Similar collector for Nexwatch credentials - [SamyRun](lf_samyrun.md) — Active HID read/clone/sim - [HID FC Brute](lf_hidfcbrute.md) — Active HID facility code brute force