diff --git a/client/src/cmdhw.c b/client/src/cmdhw.c index d2671d105..6a2db7285 100644 --- a/client/src/cmdhw.c +++ b/client/src/cmdhw.c @@ -1500,6 +1500,49 @@ static int CmdTearoff(const char *Cmd) { return handle_tearoff(¶ms, !silent); } +static int CmdBwmSetCap(const char *Cmd) { + CLIParserContext *ctx; + CLIParserInit(&ctx, "hw bwmsetcap", + "Program the BWM fuel gauge (BQ27427) Design Capacity for the fitted cell.\n" + "Run ONCE after fitting or replacing the battery. This triggers a gauge\n" + "config-update; do not run it repeatedly, as that disrupts the Impedance\n" + "Track learning cycle. PM5 only.", + "hw bwmsetcap --> set design capacity to default 500 mAh\n" + "hw bwmsetcap --cap 500 --> set design capacity to 500 mAh"); + + void *argtable[] = { + arg_param_begin, + arg_int0(NULL, "cap", "", "design capacity in mAh (default 500)"), + arg_param_end + }; + CLIExecWithReturn(ctx, Cmd, argtable, true); + int cap = arg_get_int_def(ctx, 1, 500); + CLIParserFree(ctx); + + if (cap <= 0 || cap > 32000) { + PrintAndLogEx(WARNING, "capacity out of range: %d mAh", cap); + return PM3_EINVARG; + } + + uint8_t payload[2] = { (uint8_t)(cap & 0xFF), (uint8_t)((cap >> 8) & 0xFF) }; + PrintAndLogEx(INFO, "Programming BWM gauge design capacity to " _YELLOW_("%d mAh") "...", cap); + PrintAndLogEx(INFO, "Run this " _YELLOW_("once") "; then perform a full charge/discharge learning cycle."); + + clearCommandBuffer(); + SendCommandNG(CMD_PM5_BWM_SET_CAP, payload, sizeof(payload)); + PacketResponseNG resp; + if (WaitForResponseTimeout(CMD_PM5_BWM_SET_CAP, &resp, 5000) == false) { + PrintAndLogEx(WARNING, "command timeout (is this a PM5 with a BWM fitted?)"); + return PM3_ETIMEOUT; + } + if (resp.status != PM3_SUCCESS) { + PrintAndLogEx(FAILED, "gauge provisioning failed - check BWM present and gauge unsealed"); + return resp.status; + } + PrintAndLogEx(SUCCESS, "Design capacity programmed. `hw status` should now report sane capacity."); + return PM3_SUCCESS; +} + static int CmdTia(const char *Cmd) { CLIParserContext *ctx; CLIParserInit(&ctx, "hw tia", @@ -1965,6 +2008,7 @@ static command_t CommandTable[] = { {"setmux", CmdSetMux, IfPm3Present, "Set the ADC mux to a specific value"}, {"standalone", CmdStandalone, IfPm3Present, "Start installed standalone mode on device"}, {"tia", CmdTia, IfPm3Present, "Trigger a Timing Interval Acquisition to re-adjust the RealTimeCounter divider"}, + {"bwmsetcap", CmdBwmSetCap, IfPm3Present, "Set BWM fuel-gauge design capacity (PM5, run once after battery change)"}, {"tune", CmdTune, IfPm3Lf, "Measure tuning of device antenna"}, {"decay", CmdDecay, IfPm3Present, "Measure HF antenna decay after field-off"}, {NULL, NULL, NULL, NULL}