diff --git a/Getting-started.md b/Getting-started.md index cf7fb00..e0415ea 100644 --- a/Getting-started.md +++ b/Getting-started.md @@ -16,17 +16,18 @@ To build the software and run it on the Controller we need to interface the RP20 ### Windows -1. Download and install [Pico setup for Windows from ndabas](https://github.com/ndabas/pico-setup-windows) and make sure to check the box for also installing Zadig. +1. Download and install [Pico setup for Windows](https://github.com/raspberrypi/pico-setup-windows) and make sure to check the box for also installing Zadig. 2. Clone and build Pico repos either by checking the box at the end of the setup. 3. Connect Raspberry Pi Pico via USB while holding the reset button. Your Pi Pico should now be visible in Windows explorer as a mass storage device. -4. Navigate to the picoprobe/build subfolder in your installation folder and copy picoprobe.uf2 to your Pi Pico. Alternatively, download the picoprobe.uf2 file from [here](https://www.raspberrypi.com/documentation/microcontrollers/raspberry-pi-pico.html#debugging-using-another-raspberry-pi-pico).The Pi Pico onboard LED should now be on. -5. Navigate to the tools subfolder in your installation folder and open zadig.exe -6. Install the picoprobe driver using zadig.exe as shown in [Getting started with Raspberry Pi Pico - Appendix A - Page 62](https://datasheets.raspberrypi.com/pico/getting-started-with-pico.pdf#%5B%7B%22num%22%3A65%2C%22gen%22%3A0%7D%2C%7B%22name%22%3A%22XYZ%22%7D%2C115%2C692.106%2Cnull%5D) -7. Connect GND to GND, VBUS to +V, GPIO2 to SWCLK, GPIO3 to SWDIO as shown in the picture below. +4. Download the latest prebuilt "picoprobe.uf2" release binary from [here](https://github.com/raspberrypi/pico-setup-windows) or download it from the [Raspberry Pi Website](https://www.raspberrypi.com/documentation/microcontrollers/raspberry-pi-pico.html#debugging-using-another-raspberry-pi-pico). Alternatively, you can get the file by navigating to the picoprobe/build subfolder. +5. Copy "picoprobe.uf2" to your Pi Pico. The Pi Pico onboard LED should now light up. +6. Navigate to the tools subfolder in your installation folder and open zadig.exe +7. Install the picoprobe driver using "zadig.exe" as shown in [Getting started with Raspberry Pi Pico - Appendix A - Page 62](https://datasheets.raspberrypi.com/pico/getting-started-with-pico.pdf#%5B%7B%22num%22%3A65%2C%22gen%22%3A0%7D%2C%7B%22name%22%3A%22XYZ%22%7D%2C115%2C692.106%2Cnull%5D) +8. Connect GND to GND, VBUS to +V, GPIO2 to SWCLK, GPIO3 to SWDIO as shown in the picture below. -8. To finally build and flash, open the Developer Command Prompt for Pico and type the following commands: +9. To finally build and flash, open the Developer Command Prompt for Pico and type the following commands: * git clone https://github.com/gab-k/RP2040-Decoder.git * cd RP2040-Decoder * mkdir build