From 7895ae23ee49bf4e14b51b784fa0641944b65c55 Mon Sep 17 00:00:00 2001 From: Gabriel Koppenstein <82903393+gab-k@users.noreply.github.com> Date: Thu, 18 May 2023 13:03:54 +0200 Subject: [PATCH] Initial creation of troubleshooting page --- Troubleshooting.md | 13 +++++++++++++ 1 file changed, 13 insertions(+) create mode 100644 Troubleshooting.md diff --git a/Troubleshooting.md b/Troubleshooting.md new file mode 100644 index 0000000..28e079d --- /dev/null +++ b/Troubleshooting.md @@ -0,0 +1,13 @@ +To narrow down the issue when your decoder is not working as expected, you can do the following: + + +Check the power supply of the decoder: +* +3V3 to GND should be 3.3V +* +V to GND should be somewhere in the range of around +10V to +20V +* If you dont measure the correct voltages, try to [measure Track Voltage](https://dccwiki.com/Measuring_Track_Voltage) + +Check your motor: +* Desolder your motor and try the motor with a analog power supply 0...+-16V to check if the motor is working or not (desolder the wires because the decoder doesn't like voltage on these pins!) + +Reset: +* Try to reset the decoder by writing a value of 8 to CV8 (beware, this will reset the complete CV memory!) \ No newline at end of file