Files
RP2040-Decoder/docs/sphinx/source/other/troubleshooting.md
T
2024-11-27 21:59:54 +01:00

701 B

Troubleshooting

To narrow down the issue when your decoder is not working as expected, you can do the following:

Check the power supply of the decoder:

  • +3V3 to GND should be 3.3V
  • +V to GND should be somewhere in the range of around +10V to +20V
  • If you dont measure the correct voltages, try to measure Track Voltage

Check your motor:

  • Desolder your motor and try the motor with a analog power supply 0...+-16V to check if the motor is working or not (desolder the wires because the decoder doesn't like voltage on these pins!)

Reset:

  • Try to reset the decoder by writing a value of 8 to CV8 (beware, this will reset the complete CV memory!)