Troubleshooting
To narrow down the issue when your decoder is not working as expected, you can do the following:
Check the power supply of the decoder:
+3V3 to GND should be 3.3V
+V to GND should be somewhere in the range of around +10V to +20V
If you dont measure the correct voltages, try to measure Track Voltage
Check your motor:
Desolder your motor and try the motor with a analog power supply 0…+-16V to check if the motor is working or not (desolder the wires because the decoder doesn’t like voltage on these pins!)
Reset:
Try to reset the decoder by writing a value of 8 to CV8 (beware, this will reset the complete CV memory!)