Expanded on stdio logging functionality, also configuration of logging is now entirely in CMakeLists.txt for convenience, also warns now for logging configurations that make no sense; Clarification in CV table comment; Moved pin definitions into board definition files; two_std_dev() now works mostly with integers; Added function for resetting all CVs saved in flash; Added various LOG() messages;

This commit is contained in:
gab-k committed 2024-12-22 21:48:41 +01:00
1 parent 7b1d5ed152
commit f8b99de801
9 files changed
+311 -119

No files matched your search

+6 -32
View File
@@ -26,42 +26,16 @@ typedef enum {
} error_t;
// here you can enable printf debugging (needs extra soldering and you have to enable uart in the cmake configuration)
// please note
// - if it's disabled it will be compiled completely out
// - be careful that printf debugging can change your timing behavior, for example in the pid controller limit the outputs
// like already done (only print every 100th iteration for example!)
// - also note that with logging enabled GPIO0/1 are DISABLED from decoder functions because they are used for uart to the
// outside world (this is configure automatically for you below!)
// - IMPORTANT: you have to enable uart in the cmakelists.txt to enable logging!
#define LOGLEVEL 1
#define LOG(level, ...) { if(level <= LOGLEVEL) {printf(__VA_ARGS__);}}
#define LOG(level, ...) { \
if (level <= LOGLEVEL) { \
printf("[Core %u] ", get_core_num()); \
printf(__VA_ARGS__); \
} \
}
// Constant Value of 125 x 10^6
#define _125M 125000000
// GPIO used for DCC-Signal, Motor PWM or ADC
#define DCC_INPUT_PIN 21u
#define MOTOR_FWD_PIN 23u
#define MOTOR_REV_PIN 22u
#define FWD_V_EMF_ADC_PIN 28u
#define REV_V_EMF_ADC_PIN 29u
// if logging is enabled do NOT use gpio0/1 for functions in the decoder
#if LOGLEVEL != 0
// GPIO used directly (GPIO 2-5 incl.) as outputs or to switch auxiliary output transistors (GPIO 24-27 incl.)
#define GPIO_OUTPUT_PIN_MASK (1u<<24) | (1u<<25) | (1u<<26) | (1u<<27) | (1u<<5) | (1u<<4) | (1u<<3) | (1u<<2)
#else
// GPIO used directly (GPIO 0-5 incl.) as outputs or to switch auxiliary output transistors (GPIO 24-27 incl.)
#define GPIO_OUTPUT_PIN_MASK (1u<<24) | (1u<<25) | (1u<<26) | (1u<<27) | (1u<<5) | (1u<<4) | (1u<<3) | (1u<<2) | (1u<<1) | (1u<<0)
#endif
// GPIO pin mask to prevent setting illegal GPIOs (ADC, Motor, DCC Input Pin)
#define GPIO_ILLEGAL_MASK (1u<<DCC_INPUT_PIN) | (1u<<MOTOR_FWD_PIN) | (1u<<MOTOR_REV_PIN) | (1u<<FWD_V_EMF_ADC_PIN) | (1u<<REV_V_EMF_ADC_PIN)
// GPIO pin mask with allowed outputs (AUX & GPIO (configured as outputs))
#define GPIO_ALLOWED_OUTPUTS (GPIO_OUTPUT_PIN_MASK) & ~(GPIO_ILLEGAL_MASK)
extern repeating_timer_t pid_control_timer;
extern repeating_timer_t speed_helper_timer;