LOCONETBD7OPSWMODE Base Address Device Type Device Manufacturer (NMRA number) Serial Number Pulsed (Solenoid) Slow Motion (Constantly-powered) Switch Outputs Type is Switch Command Mode DCC Aspect Signal Control Mode Signal Control Mode is enabled disabled Internal Routes are disabled enabled Bushby Bit is do turnout, sensor commands trigger routes Input Lines Loconet switch commands DCC switch commands only Command source is echo to Loconet do not echo to Loconet Route Switch Commands Turnout Type eq 0 normal high CD voltage Solenoid Pulse normal B0 (<OPC_SW_REQ>) format messages special B2 (<OPC_INPUT_REP>) format messages For switch messages, send separate Red/Yellow/Green outputs separate Red/Yellow/Green outputs (Alternate) 3-wire "Searchlight" outputs 2-wire "Searchlight" outputs Signal lamps use common anode common cathode Signals wired with flashing yellow dark flashing red flashing green Fourth aspect is enabled disabled SW1021/2022 signal broadcast: not persistent persistent Lunar Aspects are CVs <html>The "CV" column in the table above shows CV numbers, not the Op Switch number.<p>To see those, hover your mouse over a variable on the OpSw Settings pane. <p>CVs 1 and 2 are the low and high (respectively) 8-bit "Base Address" values.<p>The "Base Address" is practically limited to 2005, max. in "Switch" mode, <p>or 2032 max. when, in "Aspect" mode.<p>The "Roster" tool and its Roster entries <em> cannot</em> change the "Base Address". Basic <html> <p>This roster entry will only access the specified board if the Base Address specified above <br>was correctly entered when the roster entry was first created. You <em>cannot</em> change it in the Roster Entry. </html> Signal OpSw Settings <html><span style="color: black;"><h2><strong> Signaling Mode</strong></h2></html> <html><span style="color: black;"><h2><strong>Signal Control Configuration</strong></h2></html> <html><span style="color: black;"><h2><strong>Signal Lamp Configuration</strong></h2></html> Sw. Ctrl, Inputs Settings <html><span style="color: black;"><h2><strong> Switch Control Configuration</strong></h2></html> Turnout Type eq 1 <html><span style="color: black;"><h2><strong> Inputs Configuration</strong></h2></html>