LOCONETBD7OPSWMODE Board Address Device Type Device Manufacturer (NMRA number) Serial Number Two Position Servo (Thrown/Closed) Three Position Servo (Semaphore) Output type: enabled disabled Internal Routes are disabled enabled Bushby Bit is do turnout, sensor commands trigger routes Input Lines Loconet switch commands DCC switch commands only Command source is echo to Loconet do not echo to Loconet Route Switch Commands SERVO 1 - 'Thrown' Angle: "Closed" Angle: Output Type eq 6 "Approach" Angle: Output Type eq 6 "Approach Medium" Angle: SERVO 2 - 'Thrown' Angle: "Closed" Angle: Output Type eq 6 "Approach" Angle: Output Type eq 6 "Approach Medium" Angle: SERVO 3 - 'Thrown' Angle: "Closed" Angle: Output Type eq 6 "Approach" Angle: Output Type eq 6 "Approach Medium" Angle: SERVO 4 - 'Thrown' Angle: "Closed" Angle: Output Type eq 6 "Approach" Angle: Output Type eq 6 "Approach Medium" Angle: SERVO 5 - 'Thrown' Angle: "Closed" Angle: Output Type eq 6 "Approach" Angle: Output Type eq 6 "Approach Medium" Angle: SERVO 6 - 'Thrown' Angle: "Closed" Angle: Output Type eq 6 "Approach" Angle: Output Type eq 6 "Approach Medium" Angle: SERVO 7 - 'Thrown' Angle: "Closed" Angle: Output Type eq 6 "Approach" Angle: Output Type eq 6 "Approach Medium" Angle: SERVO 8 - 'Thrown' Angle: "Closed" Angle: Output Type eq 6 "Approach" Angle: Output Type eq 6 "Approach Medium" Angle: CVs <html><p>CVs 1 and 2 are the low and high (respectively) 8-bit "Base Address" values.<p>The "Base Address" is practically limited to 2029 (in "2-position servo" mode), or <p>2025 (in "3-position Servo" mode).<p>The "Roster" tool and its Roster entries <em> cannot</em> change the "Base Address". Basic <html> <p>This roster entry will only access the specified board if the Base Address specified above <br>was correctly entered when the roster entry was first created. You <em>cannot</em> change it in the Roster Entry. </html> OpSw Settings <html><span style="color: black;"><h2><strong>Output Controls Characteristics</strong></h2></html> <html><span style="color: black;"><p><h2><strong>Output Controls Characteristics</strong></h2></html> Servos <html><span style="color: black;"><h2><strong>Servo Characteristics</strong></h2></html> Output Type eq 2 <html><span style="color: black;"><p> "Aproach" and "Approach Medium" settings are only used<p> when operating in "Three-position" mode. Those values are<p> irrelevant for "Two-position" Servo mode and are not shown<p> here.</html>