Low 7 bytes of Address CV1 High 3 bytes of Address CV9 Decoder Address (1-511) Output Mode Address (1-2047) A Output (x10) Millisecs B Output (x10) Millisecs C Output (x10) Millisecs D Output (x10) Millisecs outputs 1+2 outputs 3+4 outputs 5+6 outputs 7+8 outputs 1+2 outputs 3+4 outputs 5+6 outputs 7+8 outputs 1+2 outputs 3+4 outputs 5+6 outputs 7+8 outputs 1+2 outputs 3+4 outputs 5+6 outputs 7+8 Accessory Mode Setting Sequential Address Mode Lenz Toggle Mode Toggle Mode output 1 Toggle Mode output 2 Toggle Mode output 3 Toggle Mode output 4 Roco Momentary Mode Ack Pin invert outputs invert output 1 invert output 2 invert output 3 invert output 4 invert output 5 invert output 6 invert output 7 invert output 8 flicker outputs flicker output 1 flicker output 2 flicker output 3 flicker output 4 flicker output 5 flicker output 6 flicker output 7 flicker output 8 Decoder Address Mode To turn off, use Output Address Mode pane In Decoder Address Mode, the decoder address is multiplied by four to get the accessory address. An offset of 1 is required to work with Lenz/Digitrax systems when compared to Roco/MERG command stations Lenz (etc) Command Stations Accessory Address to operate Roco (etc) Command Stations Accessory Address to operate Output Duration and Toggle Mode Toggle Mode is required for some systems, if in doubt, turn on The behaviour is the same as with MERG kit built decoders Duration of Output (x10 MilliSecs) 0 = continous output Toggle Mode Outputs Output behaviours: Output Address Mode To turn off, use Decoder Address Mode pane In Output Address Mode, the decoder address is the accessory address, there is no multiplication. An offset of 4 is required to work with Lenz/Digitrax systems when compared to Roco/MERG command stations Lenz (etc) Command Stations Accessory Address to operate Roco (etc) Command Stations Accessory Address to operate Output Duration and Toggle Mode Toggle Mode is required for some systems, if in doubt, turn on The behaviour is the same as with MERG kit built decoders Duration of Output (x10 MilliSecs) 0 = continous output Toggle Mode Outputs Output behaviours: