LOCONETBD7OPSWMODE
Board Address
Device Type
Device Manufacturer (NMRA number)
Serial Number
over-current
auto-reverse
DS1 mode:
over-current
auto-reverse
DS2 mode:
over-current
auto-reverse
DS3 mode:
over-current
auto-reverse
DS4 mode:
normal
lower
higher
Trip current:
enabled
disabled
Occupancy detection:
enabled
disabled
Transponding detection:
Standard
Slow
Fast
Fastest
Section 1 Occupancy Detection speed:
Standard
Slow
Fast
Fastest
Section 2 Occupancy Detection speed:
Standard
Slow
Fast
Fastest
Section 3 Occupancy Detection speed:
Standard
Slow
Fast
Fastest
Section 4 Occupancy Detection speed:
normal
increased
Sensitivity:
detection and Transponding
relay state (like the PM4x)
LEDs show:
CVs
<html>The "CV" column in the table above shows CV
numbers, not the Op Switch number.<p>To see those, hover
your mouse over a variable on the OpSw Settings pane.
<p>CVs 1 and 2 are the low and high (respectively) 8-bit
"Base Address" values.<p>The "Base Address" is practically
limited to 2040, max.<p>The "Roster" tool and its
Roster entries <em> cannot</em> change the
"Base Address".
Basic
<html>
<p>This roster entry will only access the specified
board if the Base Address specified above <br>was
correctly entered when the roster entry was first created.
You <em>cannot</em> change it in the Roster Entry.
</html>
OpSw Settings
<html><h2>Section "Mode"
<html><h2>Occupancy Detection
<html><span style="color: green;"><em>The "Occupancy Detection Speed" settings, below, apply to
PM74 "July 1, <p>2024 (version Rev 7)" and later firmware. Previous firmware versions
do <p>not implement these OpSws.
<html><h2>Transponding
<html><h2>Outputs