The transmit power was hardcoded to 19.5 dBm. Some setups need a lower
value (device right next to the AP, weak 3.3V rail), so it is now a user
setting instead of a per-chip constant.
- wlan.cpp: load/save/apply TX power (0.1 dBm steps, NVS key wifi_txpwr,
default 195), re-applied on GOT_IP so it survives a reconnect
- website.cpp: /api/wifi-power GET/POST with validation
- setup.html: "WiFi Settings" card
- README.md/README.de.md: pin table gets an ESP32-S3 column plus a warning
that GPIO19/20 are the native USB data lines
- config.cpp: same warning next to the HX711 pin definitions
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>